Call now to get tree helping such as tree cutting, tree notch, bush clean, shrub dig, stump felling and a lot more within USA:


Call us

Call +1 (855) 280-15-30






The possibilities are endless!

May 11, BMW e30 rear subframe bushing removel and install. Bavarian Autosport Subframe Bushing Tool InStock Ships Today!CallMay Qualify For FREE SHIPPING. Parts# BAV ES shrubdrop.buzz BAVES X5.

Aug 01, When removing the rear subframe on an E30, there is always a possibility that either of the two old bushings will be oxidized and therefore seized/stuck in the body. The OE subframe bushings are made up of an aluminum sleeve with a thick rubber coating around it. The aluminum sleeve protrudes at the top of the bushing and seats into the body during. e30 Subframe bushing puller tool.AM. Sub-Frame bushing puller for E30s and Z3s.

I've used this tool to pull approximately 25 sets of bushings so this is a proven design that decatur tree removal, 2451 Waltham MA pulling sub-frame bushings an easy job.

Price isshipped and the item ships from North Carolina. Place BMW Special Tool # 33 3 on top of sub frame and screw in # 33 3 through bushing. Place Tool # 33 3 on base of bushing and screw on nut # 33 3 Tighten 24 mm nut until bushing is fully seated in sub frame. Allow tool to sit, tightened, on bushing for at least 10 minutes to ensure bushing remains seated.

Dec 31, e30 rear subframe bushings-replace or leave. Discussion in 'E30 ' started by 02m3smg2b, Jun 7, 02m3smg2b guest.

Replacing the rubber subframe bushings is not an easy diy job. You'll likely need a press to get new rubber ones in. trailing arm removal.

Sign Up!

Get it as soon as Tue, Aug FREE Shipping by Amazon. Only 1 left in stock - order soon. Rear Subframe Differential Rear Bushing Tool Kit Compatible For BMW F01, F02, F04, F06, F07, F10, F13, F18 Engine Type.

out of 5 stars. 7. The bushing removal tool consists of the through bolt, an upper threaded piece that will fit the subframe and pull the bushing as the rod is threaded into it, an upper alignment ring that fits on the bottom of the subframe bushing mount, a bushing receiving cylinder and the lower alignment disc that will support the force of removal.